Three addresses, one market. Same account, same orders, same balance behind each one. No accounts, no forms, nothing collected

HomeSignals › Unable to connect to the onionsite

Unable to connect to the onionsite

The 0xF3 error sits between a lookup failure and a real page, and it usually says more about your circuit than about the Nexus mirror.

Group
Reachability
Browser code
0xF3
First move
Retry, then switch
How long to give it
One minute
Nexus Market onion addresses3 live · same market behind each
nexusb2l7fmqnefwphyy7m5zjhlkytlbo7qbb5lu5dlczr3azgii2gyd.onion
nexusma2iqgauqqvjcgds4ckv5xbf272tkfagq4epojjhsgleqpwxiqd.onion
nexusabcd6tyfhdwilyitaqiri6tisj2v2hueyjuj6qkvd6azvi5tuqd.onion

Run the check before you sign in. Open these in Tor Browser only. When the login screen loads, compare the onion printed on the page against your address bar, reading from the end. If they differ, close the tab.

Descriptor found, introduction attempted, handshake did not complete. Of all the reachability errors this is the one most likely to be your side of the connection.

What you see. An error page saying the onionsite could not be reached, with the code 0xF3, often after thirty to sixty seconds of waiting.

Where it breaks

Connecting to an onion service takes a small negotiation. You pick a relay to act as a meeting point, tell the service about it through one of its introduction points, and both sides build circuits to that meeting point. This error means the negotiation started and did not finish. Any of the six or so relays involved can be the reason.

Why your side is the usual suspect

A service under load fails at introduction and reports it consistently. A single unlucky relay in your own path fails intermittently, which is what most people actually see. If the same address opens on the next try, or opens after you request a fresh circuit, the fault was in the path and not at the far end.

What to do

  1. Retry once. Different relays get chosen and the problem often evaporates.
  2. If it repeats, request a new circuit for the site from the browser menu and try again.
  3. If it still repeats, try another mirror. Two addresses failing the same way points away from your path.

A note on timing

This error takes longer to appear than the other two because the client waits for a handshake that never lands. A long wait ending in 0xF3 is normal for this error and does not mean anything extra.

How to read the result

Once, then fine

A relay in your path had a bad moment. Nothing to read into it, and nothing to change.

Repeats on one address

Get a new circuit for that site before deciding anything. Most repeats stop there.

Repeats on all three

Your Tor client is having a wider problem. Restart the browser fully, which rebuilds guards and circuits from scratch.

Other reachability signals

Procedures that apply here